- Completely disassemble your engine and inspect each component for wear or damage
- Disassemble your cylinder heads and inspect for wear or damage
- Check valves, valve guides and seats
- Boil block, brush oil galleys and tap head bolt and main cap holes
- Paint outside of block with hi-temp paint
- Magnaflux crankshaft and rods
- Check rod and crank sizing, polish crankshaft
- Install new cam bearings
- Hone block with torque plate
- Disassemble and inspect oil pump
- Assemble complete engine, check all bearing clearances and end play
- Degree cam, check piston to valve clearance, verify top dead center
- Assemble cylinder heads, check spring pressure, set spring heights and install new seals
- Break-in engine on dyno to seat rings and test power output
- Check for leaks, verify proper oil pressure, check individual cylinder leakage and compression
- Cut oil filter open and inspect
|
|
